The following 171 commands are supported by the Boson NetSim LE for the labs in the CCNA ICND Exam Certification Guide The following 92 commands are supported by the Boson NetSim LE for the labs in the CCNA INTRO Exam Certification Guide.
#Boson netsim review software#
The list of commands are a direct pull of what the software is expecting.
#Boson netsim review full#
The list of commands includes the full syntax of the commands, so you can compare the commands you're typing to what NetSim is expecting.
If you're having difficulty getting a supported lab to work, you might benefit from reading over the list of commands that Boson NetSim LE supports in each lab. For your convenience, a complete listing of all modern commands that are enabled for completing the included labs (that are documented as enabled in the printed books) are listed below.Īlso note that Boson NetSim LE doesn't let you make as many mistakes as a real router or switch - for instance, using a different subnet mask than the lab requires will be rejected by NetSim. The Boson NetSim™ LE (or Learning Edition) software product, as provided on the CDROM within the CCNA INTRO and CCNA ICND (640-8xxx series) books, simulates only those newer, or more modern, Cisco recommended and documented commands. While this CLI command may still work, it is no longer documented in current Cisco courseware, and is no longer recommended. Method #2: The older (or “legacy”) CLI command, “Write Mem”, performs an identical save of the same Cisco router’s configuration data. This CLI command is well documented in modern Cisco courseware, and is the currently recommended method.
Method #1: The newer (or “modern”) CLI command, “Copy Run Start”, performs a save of the Cisco router’s configuration data.
For example, there are several different ways to configure a Cisco router to perform a save of its configuration data: This can be observed in interesting ways, all the way down to the Cisco router and Catalyst switch command line interface (or, “CLI” for short) level. What that means is that the exact commands required for those labs indeed work, but commands that aren't required for those labs aren't supported in the product.Īs technology evolves, various technical recommendations provided by the numerous standards committees (and manufacturers that are affected by those modifications), change with the times. Difference between CCNA 2.0 material and the new ICND/INTRO materialīoson NetSim LE functionality and supported commandsīoson NetSim LE has been specifically designed to support several labs from this book.
0 kommentar(er)
